Getting started -123, Getting started, Choosing a language – NISSAN 2010 Maxima User Manual

Page 284: Connecting procedure

Advertising
background image

You can also use the

button

to interrupt the system feedback
and give a command at once. See
“List of voice commands” and
“During a call” in this section for
more information.

PHONE/END

While the voice recognition sys-
tem is active, press and hold

the

button for 5 seconds to

quit the voice recognition system
at any time.

TUNING SWITCH

While using the voice recognition
system, tilt the tuning switch up or
down to manually control the
phone system (if so equipped).

GETTING STARTED

The following procedures will help you get
started using the Bluetooth

ா Hands-Free Phone

System with NISSAN Voice Recognition. For ad-
ditional command options, refer to “List of voice
commands” in this section.

Choosing a language

You can interact with the Bluetooth

ா Hands-Free

Phone System using English, Spanish or French.

To change the language, perform the following.

1. Press and hold the

button for more

than 5 seconds.

2. The

system

announces:

“Press

the

PHONE/SEND (

) button for the

hands-free phone system to enter the
speaker adaptation mode or press the
PHONE/END (

) button to select a dif-

ferent language.”

3. Press the

button.

For information on speaker adaptation, see
“Speaker adaptation (SA) mode” in this sec-
tion.

4. The system announces the current language

and gives you the option to change the lan-
guage to Spanish (in Spanish) or French (in
French). Use the following chart to select
the language.

NOTE:

You

must

press

the

button

or

the

button

within

5

seconds

to

change the language.

Current

language

Press

(PHONE/SEND)

to select

Press

(PHONE/END) to

select

English

Spanish

French

Spanish

English

French

French

English

Spanish

5. If you decide not to change the language, do

not press either button. After 5 seconds, the
VR session will end, and the language will
not be changed.

For color monitor system language change, see
“Language/Units” in this section.

Connecting procedure

NOTE:

The connecting procedure must be per-
formed when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.

Monitor, climate, audio, phone and voice recognition systems

4-123

Advertising