Nikon NP64 - Manual (Page 37)

28
3. Projecting an Image (Basic Operation)
➐ Adjusting Volume Up & Down
Sound level from the speaker on the projector can be adjusted.
Another way to adjust volume is to use the menu.
Select [ADJUST]
→ [BASIC] → [VOLUME] from the menu.
NOTE: The [BEEP] sound volume cannot be adjusted. To turn off the [BEEP] sound, from the menu, select [SETUP] → [OPTIONS (1)]
→ [BEEP] → [OFF].
AUTO
ADJ.
ON/STAND BY
FOCUS
LAMP
STATUS
POWER
❽ Turning off the Projector
To turn off the projector:
First, press the POWER (ON/STAND BY) button on the
projector cabinet or the POWER OFF button on the re-
mote control. The “POWER OFF / ARE YOU SURE? /CAR-
BON SAVINGS- SESSION X.XXX[g-CO2]” message will
appear.
Secondly, press the ENTER button or press the POWER
(ON/STAND BY) or the POWER OFF button again.
The power indicator will glow orange.
POWER
STATUS
LAMP
POWER
STATUS
LAMP
STATUS
LAMP
POWER
Power On Fan running Standby
Steady green light Blinking
orange light
Steady green/
orange light
CAUTION:
Parts of the projector may become temporarily heated if the AC power supply is disconnected either during nor-
mal projector operation or during cooling fan operation. Use caution when picking up the projector.
NOTE:
• The projector cannot be turned off with the ON/STAND BY button or the POWER OFF button while the POWER indicator is
flashing green in a cycle of 0.5 second on and 0.5 second off.
• Do not disconnect the AC power supply to the projector for 60 seconds immediately after turning it on and displaying an im-
age.
• Do not turn off the projector using the “Direct Power Off” function within 10 seconds of making adjustment or setting chang-
es and closing the menu. Doing so can cause loss of adjustments and settings.