Network Technologies NTI VOPEX VOPEX-C5SV-x - Manual (Page 8)

5
2. Connect the local user to the VOPEX-C5SVA-x (see Fig. 2)
a. Connect one end of another SVEXT-xx-MM cable to the 4-pin miniDIN female connector
marked "S-Vout" on the VOPEX-C5SVA-x.
b. Connect the other end of the SVEXT-xx-MM cable to the 4-pin miniDIN female connector on the
local s-video display.
c. Connect the cable from the local speakers into the 3.5mm stereo audio connector marked "Line
Out" on the VOPEX-C5SVA-x.
Figure 2- Connect Local User components and CAT5 cable to VOPEX-C5SVA-8
3. Connect a CAT5 cable to any one of the “Cat5x” ports on the VOPEX-C5SVA-x. (See Fig. 2.)
When properly inserted the cable end should snap into place.
4. Repeat step 3 for each ST-C5SVA-R-600 Receiver to be connected to the VOPEX-C5SVA-x.
Note: If an RJ45 wall outlet is being used, connect the other end of the extension cable to the
RJ45 wall outlet.
WARNING: Never connect the VOPEX-C5SVA-x Extender/Splitter to an ethernet card,
ethernet router, hub or switch or other ethernet RJ45 connector of an ethernet device. Damage to
devices connected to the ethernet may result.
!
S-Video
Display
CAT5 Cable to
ST-C5SVA-R-600
Receiver
Local User's Display and Speakers
5VDC
2A
- + 8 7 6 5 4 3 2 1
Line
Out
Line
In
Cat5
NTI
NETWORK TECHNOLOGIES
INCORPORATED Tel:330-562-7070
Fax:330-562-1999 1275 Danner Dr
Aurora, OH 44202
ww w.nti 1.com
R
VOPEX-C5SVA-8
(Rear View)
3.5mm Female
Stereo Audio
Connector
S-Vin S-Vout
4-pin miniDIN Female
S-Video Connector
VIDEO
CONNECTOR
SVEXT-xx-MM