NordicTrack NTBE06900 - Manual (Page 10)

10
50
2
29
15
29
17
17
32
24
23
25
25
23
32
34
37
37
40
4
40
25
25
14
16
45
41
41
16. Wet the ends of the Lat Bar (45) with a small
amount of soapy water. Slide the Handgrips (41)
onto the ends of the Lat Bar.
17. Make sure all parts of the weight rack are prop-
erly tightened. In addition, pull each cable a few
times to make sure the cables move smoothly
over the pulleys. If the cables do not move
smoothly, locate and correct the problem. When
weights are used, the cables may be damaged if
they are incorrectly routed.
The use of all remaining parts will be explained in
ADJUSTING THE WEIGHT RACK, beginning on
page 11.
14. Pull the Cable (25) down in the indicated location,
so there is no slack at the ends of the Cable.
Locate the other Cable (25). Insert the metal-sleeve
end of the Cable into the indicated hole in the
Weight Guide Base (4). Attach the Cable using a
3/8Ó x 3Ó Bolt (34), two 3/8Ó Washers (37), two
15/16Ó Spacers (40), and a 3/8Ó Nylon Locknut (29).
Route the ball-end of the Cable (25) through the
bracket on the Center Base (2). Attach a 4Ó Pulley
(50) inside the bracket using a 3/8Ó x 2Ó Bolt (32)
and a 3/8Ó Nylon Locknut (29).
15. Wrap the upper Cable (25) around a 3 1/2Ó Pulley
(24) as shown. Attach the 3 1/2Ó Pulley and a Cable
Trap (23) to the two Pulley Plates (17) using a 3/8Ó
x 2Ó Bolt (32) and a 3/8Ó Nylon Locknut (29).
Wrap the other Cable (25) around a 3 1/2Ó Pulley
(24) as shown. Attach the 3 1/2Ó Pulley and a Cable
Trap (23) to the Pulley Plates (17) using a 3/8Ó x 2Ó
Bolt (32) and a 3/8Ó Nylon Locknut (29).
Make sure the Bolts (32) are inserted through
the highest and lowest holes in the Pulley Plates
(17), and that the Cables (25, 26) are between
the Cable Traps (23) and the 3 1/2Ó Pulleys (24).