Niles Audio CAM-DFMK - Manual (Page 7)

5
FLUSH-MOUNT
The flush-mount kit is used to acheive low-profile installations where stealth and concealment are
priorities. A hole must be cut in the desired mounting surface.
TO INSTALL CAMERA USING FLUSH-MOUNT KIT:
1. Cut a 3 1/4” diameter hole in mounting surface.
2. Place camera inside of camera housing base. Make sure wires extend through base.
3. Place camera housing top on camera housing base and secure with two 1/4” screws.
4. Connect wires.
5. Place assembled camera housing into main bracket. Place bayonet mount over camera housing
and attach to main bracket with three 1/2” screws. Do not tighten completely.
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Figure 7
Figure 8
Figure 9
Figure 10
NILES AUDIO CORPORATION – 1-800-BUY-HIFI
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
DS00470ACN-0 CAM-DFMK small.indd 7 1/11/06 11:19:50 AM