Niles Audio CAM-DFMK - Manual (Page 8)

6
6. Place entire assembly into hole.
7. Turn dog screws clockwise until dogs are snug. Over-tightening dogs can keep trim ring from
snapping in place. If trim ring does not snap into place, loosen screws slightly.
NOTE: ACCESS HOLES ARE PROVIDED TO LOOSEN DOGS IN CASE THEY BECOME STUCK.
8. Make provisions to view the camera image and point the camera at the desired location.
IMPORTANT: MAKE SURE THAT THE IMAGE IS LEVEL!
9. With camera properly aimed, tighten screws.
10. Align trim ring with slots in bayonnet mount. Snap in place.
11. To remove trim ring, insert small, flat screwdriver tip into one of three slots on outer edge
and pry off.
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Figure 11
Figure 12
Figure 13
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
Main
bracket
Camera
housing base
Camera
housing top
Bayonet
mount
Trim ring
3 1/4" inch
diameter hole
Use 1/4" screws
Use 1/2" screws
Rear view
Front view
Access holes
DS00470ACN-0 CAM-DFMK small.indd 8 1/11/06 11:19:59 AM