Nvidia NFORCE 650I - Manual (Page 65)

Mainboard nForce 650i Ultra
61
Rebuilding a RAID Mirrored Array
This section will illustrate how to replace a failed drive with a new one, and rebuild the array
to restore lost data on the newly installed drive. Rebuilding only applies to fault-tolerant
arrays which are RAID 1, RAID 0+1, and RAID 5 arrays.
1. Before rebuilding an array, you must connect new hard disk(s) onto your computer.
2. Power on your computer. When the system boots up during the POST (Power-On Self
Test), you will be given an opportunity to enter the NVIDIA RAID Setup Utility when the
screen prompts you with the following message.
“Press ＜F10＞ to enter RAID setup utility…”
3. Press <F10> key to enter the NVIDIA RAID Setup Utility (note that you will only have a
short window of time to press <F10> before the system continues the next step of the boot
process).
4. Go to the screen shown as below. Press <Enter>.