NEC XV17+ - Manual (Page 21)

Problem Check These Items
Display image is not centered, too
smaIl, or too large Use the OSM Size and Position
controls to adjust the image.
Color looks blotchy Adjust the Brightness, then Contrast
Controls. Access the Degauss Control
through OSM. Activate the Degauss
Control. CAUTION: A minimum
interval of 20 minutes should exist
before the Degauss Function is used a
second time.
Specifications
Picture Tube 43 cm (17 inch) flat square CRT, 39.6 cm (15.6 inch)
viewable image size, 0.28 mm dot pitch, Medium-Short
persistence phosphor, semi tint screen, multi-layered,
anti-static OptiClear coating
Input Signal Video Analog 0.7 Vp-p 75
Ω
Positive
Sync Separate sync.
Horizontal sync.
Vertical sync.
Composite sync. TTL Level
Positive/Negative
Positive/Negative
TTL Level
Positive/Negative
Display Colours Analog Input: Unlimited colours
(Depends on the graphics board)
Synchronisation
Range Horizontal 31 kHz to 82 kHz (Automatically)
Vertical 55 Hz to 100 Hz (Automatically)
Resolutions Maximum 1280 x 1024 (75 Hz non interlaced)**
Recommended 1024 x 768 (75 Hz non interlaced)*
Video Band Width 85 MHz (Typ.)
Active Display
Area (Factory
Setting) Horizontal 306 mm (Active display area is
dependent upon the signal timing)
E - 16 Specifications