New Transducers 37PF9830/10 User Manual
Page 12
12
Menu preferences
OSD
&
Select
OSD
.
é
Press the cursor right to select
Normal
or
Minimum
.
Normal
to activate the continuous display of the channel number (for 10
minutes) and extended display of TV channel and programme information
on screen. E.g. information on the main or auxiliary programme, input signal
quality of connected peripheral equipment, the display format and sound
mode.
Minimum
to activate the display of reduced channel information.
See Use of the remote control, p. 4, i Display information.
Programme title
&
Select
Programme title
.
é
Press the cursor right to select
Programme title Yes
or
No
.
When selected
Yes
, after the selection of a TV programme or after pressing
the i key on the remote control, a TV channel may transmit the name of
the TV channel or the programme title.
When selected
No
, the programme title will only appear after pressing the
i key and not after the selection of a TV channel.
Set/Change code
&
Select
Set
or
Change code
with the cursor down.
é
If no PIN-code exists yet, the menu item is set to
Set code
. Follow the
instructions on screen.
If a PIN-code has previously been entered, the menu item is set to
Change
code
. Follow the instructions on screen.
All number combinations from 0000 tot 9999 are valid numbers.
“
The
Menu preferences menu
reappears with a message confirming that
the PIN has been created.
Factory settings
This function allows you to reset most of the picture and sound settings to
their predefined factory states.
&
Select
Factory settings
with the cursor down.
é
Press the cursor right.
“
Press the
OK
key to erase settings and reset them to their default values.
Important:You have forgotten your code !
&
Select
Change code
in the Menu preferences menu and press
OK
.
é
Press the cursor right and enter the overriding code 8-8-8-8.
“
Press the cursor again and enter a new personal 4-digit code.The previous
code is erased and the new code is stored.
Settings/Setup
Preferences
Picture/sound preferences
Features preferences
Menu preferences
Factory settings
Menu preferences
OSD
Programme title
Set/Change code
Info