New Transducers 37PF9830/10 - Manual (Page 32)

32
Your TV remote control gives you the opportunity to control all your peripheral equipments with one single remote control.This can be
done by selecting the correct brand and type out of the list of Direct Entry codes for peripheral equipments.
Press the SELECT key repeatedly to select DVD/R , SAT , VCR or AUX according to the peripheral equipment you want to operate with
this remote control. See Use of the Remote control, p. 4. If the function keys on the remote control also work the selected peripheral
equipment, then the remote is ready and no further steps are needed.
If the function keys do not work with the selected peripheral equipment, according to the equipment(s) you own, you may make your
remote control ready for them by a direct entry code. Proceed as following.
+
-
+
-
DVD/R TV VCR AUX
MENU
1 2 3
®
®
® ®
SELECT
DEMO
=
SAT
BROWSE
b
MOT
B
v k
T
b
¬ P V
OK
JKL GHI MNO
ABC
_-
DEF
Code setup
& Press the SELECT key repeatedly to select your source according to the
peripheral equipment you want to operate with this remote control.
é Press the SELECT and B key at the same time for longer than 4 seconds.
The selected mode LED will lit constantly.
“ Input the 3-digit code for the type and brand of peripheral equipment.The
codes are listed on page 33.
‘ The selected mode LED will blink fast for 5 seconds as a confirmation you
entered a correct code.The remote will go back to the last selected mode.
If you entered a wrong code the mode LED will stay on for 2 seconds.
Redo step
“ .
( Now you will try to use the TV remote with the peripheral equipment.
Press the
SELECT key repeatedly to select the desired mode.The selected
mode LED will stay on for 2 seconds and then begin blinking.The blinking
means that the remote is in the external mode you have selected.
§ Within 60 seconds from the time the blinking starts, point the remote
toward the peripheral equipment and press the B key. If the peripheral
equipment does not respond to the B command, follow the steps for
programming the remote again using a different setup code for the type
and brand of peripheral equipment you wish to operate. Refer again to the
code list on page 33. If no more codes are listed for the type and brand of
external equipment, the remote likely will not operate your particular
model of peripheral equipment.
Notes:
- Your TV remote is not necessarily capable of being programmed to operate all
models of the brands of peripheral equipments listed on page 33.You may want to
try the programming process again. Try using the number(s) that are listed for your
type and brand of peripheral equipment to be sure you did not make a mistake in
inputting the digits during your first attempt at programming.
- If the remote control is in one of the external modes (a mode light is flashing) —
DVD/R, SAT, VCR or AUX — and you don’t press any of the remote keys for sixty
seconds, a “time-out” occurs, returning the remote to TV mode.
To cancel the selected mode
Press the SELECT key for 2 seconds.
The remote control will return to TV mode.
Setting the remote control to work peripheral equipment