Newcon Optik LRB 3000PRO - Manual (Page 17)

13
To activate the Scanning regime press and hold the A button
in the Ready mode. The unit will work in the Scanning
regime while the A button is pressed.
The Scanning or Individual Measurement regimes are
available for any selected mode of measurement. When two
parameters are measured in the Scanning regime though both
will be quickly displayed, the second one may be difficult to
register by eye. Nevertheless all data is recorded and may be
recalled (see Data Recall mode for details.)
Operation and service modes
Pressing Mode button (3, Fig.1) in Ready mode switches the
unit between modes of operation, to activate any desired
mode from the menu you must confirm your selection by
pressing Action button (4, Fig.1)
The unit has the following modes of operation:

Ready – Unit is ready to perform measurements
 dFLt – sets default mode of operation with factory
settings,
 Std – allows the user to select single action
measurements:
o Distance only (d)
o Compass Only (C)
o Elevation Only (E)
o Speed Only (S)