Newcon Optik LRB 3000PRO - Manual (Page 21)

17
Data Recall mode
In Data Recall mode results of the last 10 measurements can
be displayed.
Measurement results are saved in on-board memory in sets
depending on the parameters set for measuring, for instance,
if only distance is measured - the set will consist of one
number, if distance and azimuth are measured – the set will
consist of two numbers.
To enter Data Recall mode select
rEc from main menu.
First measurement set number (display name: rEc 1 ) will
start flashing.
Pressing M button moves the unit along the list of
measurement set numbers and measurement results:
rEc 1 , distance 1, azimuth 1,
rEc 2 , distance 2, azimuth 2,
rEc 0 , distance 0, azimuth 0.
Measurement sets are numbered in reverse order: first
recalled set is the result of the last measurement. If any
parameter has not been actually measured it will not be
recalled.
Pressing A button at any moment within the list of recalled
results brings the unit to Ready to Measure mode.
Choosing
cLr
at the end of recalled data will erase the
device memory.