NorthStar Navigation 10 kW - Manual (Page 32)

ƒ If you want the radar to power ON automatically whenever the 6000i or 6100i is ON, use the
following power ON/OFF configuration:
where:
Key Component
A Radar processor
B Main PCB
C NMEA/Comms port
E Relay with (normally) closed contact
F Fuse
G NMEA port
H Power port
I Fuse /Breaker board
J and K Battery
ƒ If you want the radar to power ON automatically when the radar processor is powered ON,
omit the relay and leave Pin 10 and 12 on Connector 1 (the NMEA/Comms connector) as No
Connect.
3.10.3.8 Connect the 10 kW radar processor to an 8000i display
You are recommended to use the following configuration when connecting the radar processor to an
8000i display, where A is the (optional) NMEA Compass, B is the Circuit breaker/Fuse box, and C is the
vessel's Ground.
Northstar 10 kW Radar Installation Manual 32