Nortel Networks BST Doorphone - Manual (Page 15)

Chapter 4 Configuring BST Doorphone settings 15
BST Doorphone Installation and Configuration Guide
Chapter 4
Configuring BST Doorphone settings
Doorphone programming allows you to customize feature settings for individual BST Doorphones
on the BCM system.
Follow these steps to configure Doorphone settings:
1 From Element Manager, click on the Configuration tab and select Telephony > Sets >
Active Sets.
2 Click on the Doorphone you want to program (for example, Doorphone 1) and select the
Capabilities and Preferences tab.
3 Select the Preferences tab from the details panel, and set the Dialing Options to Standard
dial.
4 Select the Doorphone Settings tab from the details panel.
5 Use the information in Table 4 to change the Doorphone settings.
6 Repeat these steps for each BST Doorphone installed on the system.
Note: A maximum of 250 BST Doorphones can be attached to the BCM system.
Table 4 BST Doorphone settings (Sheet 1 of 2)
Setting Values Description
Doorphone state Active This read-only field indicates if the Doorphone is detected on
the system and is operational.
Speaker volume Low
Medium
High Assign a volume level for the Doorphone speaker.
Chime volume Low
Medium
High Assign a volume level for chime tones played during a
Doorphone page.
Call Action Ring Set
Page
Both Select a call activity when the Doorphone Call button is
pressed.
Ring Set: Calls an internal telephone.
Page: Sends a page tone to a specific group of telephones in a
page zone.
Both: Calls an internal telephone. If the call is not answered
after a set length of time, a page tone is sent to a specific
group of telephones in a page zone.
Target DN < any telephone DN> Enter the DN number of the internal telephone to call when the
Doorphone’s Call button is pressed.
Ring Delay 1 to 60 seconds Select a set length of time (in seconds) to allow ringing at the
Target DN before the call is automatically disconnected.