Raypak RAYTHERM 0133-4001 - Manual (Page 8)

VENTING
OUTDOOR INSTALLATIONS
MODEL 133
Step 1: Remove the front (4) screws.
Step 2: Line up outdoor top vent opening over heater
vent opening.
Step 3: Lower outdoor top onto unit lining up slots in
the outdoor top with screws holes in jacket top.
Step 4: Reinstall (5) screws to secure jacket top and
outdoor top to unit.
Fig. #8114
MODELS 514 - 824
Step 1: Lower outdoor top onto unit. Position top so it
is centered on unit from side to side and front
to rear.
Step 2: Tighten the (4) screws (Shown below) until
they come in contact with the unit jacket top,
then evenly tighten all (4) screws to secure to
unit.
JACKET TOP
FASTENING
SCREW
Fig. # 8233
MODELS 926-1758
Boilers are shipped with outdoor vent terminal
factory installed.
Fig. # 8166.1
8
Fig. #RP8280.1
Outdoor Top
(Shipped Loose with Heater)
MODELS 181-401 and 182-400
Outdoor Top Installation
Step 1: Remove jacket top panel.
Step 2: Remove and discard inner stack adapter
panel.
Step 3: Install jacket top panel.
Step 4: Insert tabs of outdoor top into keyholes located
on jacket top panel (4 places). See Detail A
Step 5: Snap tabs on outdoor top into the locked
postion of the keyhole so the top will not pull
out. See Detail B
Detail A Detail B
(Part of heater)
Fig. # 9389