Ryobi TS1350 - Manual (Page 16)

Page 16
ADJUSTMENTS
WARNING:
Failure to unplug your saw could result in accidental
starting causing possible serious personal injury.
■ Push down on the saw arm and pull out the lock pin to
release the saw arm.
■ Raise saw arm to its full raised position.
■ Loosen the miter lock handle approximately one-half
turn.
■ Depress the miter lock plate and rotate the miter table
until the pointer on the control arm is positioned at 0
° .
■ Release the miter lock plate and securely tighten the
miter lock handle.
■ Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Place the other leg
of the square beside the zero clearance throat plate in
the miter table. The edge of the square and the zero
clearance throat plate in the miter table should be paral-
lel as shown in figure 19.
■ If the edge of the framing square and the zero clearance
throat plate in the miter table are not parallel as shown
in figures 18 and 19, adjustments are needed.
■ Loosen the socket head screws securing the fence. See
Figure 20. Adjust the fence left or right until the framing
square and zero clearance throat plate are parallel.
■ Retighten the screws securely and recheck the fence-
to-table alignment.
FRAMING
SQUARE
Fig. 18
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER FENCE
ZERO CLEARANCE
THROAT PLATE
MITER TABLE
FRAMING
SQUARE
MITER
FENCE
Fig. 19
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER TABLE
ZERO CLEARANCE
THROAT PLATE
0
22.5
30
15
31.6
22.5
30
15
31.6
455
45
Fig. 20
FENCE
SOCKET HEAD
SCREW(S)
SOCKET HEAD
SCREW(S)