Ryobi TS1350 - Manual (Page 9)

Page 9
30
4 5
15
2 2 .5
31.62
0
15
30 45 22.5 31.62
0
FEATURES
Fig. 2
LOWER
BLADE GUARD
DUST GUIDE
UPPER
BLADE GUARD
SAW ARM
MITER
FENCE
MITER TABLE
MITER
LOCK HANDLE
BEVEL
SCALE
BEVEL
LOCK KNOB
POSITIVE STOP(S)
SWITCH TRIGGER
ZERO CLEARANCE
THROAT PLATE
"NO HANDS ZONE"
LABEL
CONTROL ARM
MITER
LOCK PLATE
"NO HANDS ZONE"
BOUNDARY LINE
MITER
TABLE FRAME
MITER SCALE
KNOW YOUR COMPOUND MITER SAW
See Figure 2.
Before attempting to use your saw, familiarize yourself with
all operating Features and Rules for Safe Operation.
WARNING:
Do not allow familiarity with your saw to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
15 AMP MOTOR
Your saw has a powerful 15 amp motor with sufficient power
to handle tough cutting jobs. It is made with all ball bearings.
10 in. BLADE
A 10 in. (254 mm) saw blade is included with your compound
miter saw. It is fine for most wood cutting operations, but for
fine joinery cuts or cutting plastic, use one of the accessory
blades available from your nearest Ryobi dealer.
CUTTING CAPACITIES
When the miter angle (miter table) is set at 0
°
and the
bevel angle is set at 0
°
:
Your saw will cut materials up to a maximum of 5-5/8
in. (143 mm) wide x 2-5/8 in. (67 mm) thick.
When the miter angle (miter table) is set at 45
°
and the
bevel angle is set at 0
°
:
Your saw will cut materials up to a maximum of
3-1/2 in. (89 mm) wide x 2-5/8 in. (67 mm) thick.
When the miter angle (miter table) is set at 0
°
and the
bevel angle is set at 45
°
:
Your saw will cut materials up to a maximum of
5-5/8 in. (143 mm) wide x 1-9/16 in. (40 mm) thick.
When the miter angle (miter table) is set at 45
°
and the
bevel angle is set at 45
°
:
Your saw will cut materials up to a maximum of
3-15/16 in. (100 mm) wide x 1-9/16 in. (40 mm) thick.
BLADE
WRENCH