Radio Shack 13-1317 - Manual (Page 7)

7
5'48+%'"#0&"4'2#+4
If your stereo is not performing as it should,
take it to your local RadioShack store for
assistance. Modifying or tampering with the
stereo’s internal components can cause a
malfunction and might invalidate its
warranty.
%&"%#4'"6+25
Even though a compact disc is durable, treat
the CD surface with care.
• Do not write on either side of the CD,
particularly the non-label side (signals
are read from the non-label side).
• Do not store CDs in high temperature or
high humidity areas. They might warp.
• Keep CDs dry. A water drop can act as
a lens and affect the laser beam's
focus.
Always handle a CD by the edges to avoid
fingerprints and always keep it in its
protective case or sleeve when it is not in
use. Fingerprints and scratches on the CD's
surface can prevent the laser beam from
correctly reading the digital information. If
the CD gets scratched, use RadioShack
Scratch 'n Fix to repair the disc.
6#2'"6+25
4
'5614+0)
"6
#2'
"6
'05+10
"
#0&
"5
170&
"3
7#.+6;
After you play a cassette tape several times,
the tape might become tightly wound on the
reels. This can cause playback sound
quality to deteriorate.
To restore the sound quality, fast-forward
the tape from the beginning to the end of
one side, then completely rewind it. Then
loosen the tape reels by gently tapping each
edge of the cassette on a flat surface.
. . . .
'
4#5+0)
"6
#2'5
To record over a cassette tape, simply
record as usual. The cassette deck records
over the previous recording.
You can quickly erase both sides of a
cassette tape using a RadioShack bulk tape
eraser.
±
2
4'8'06+0)
"#
%%+&'06#.
"
'
4#574'
Cassette tapes have two erase-protection
tabs — one for each side. When a tab is in
place, you can record on that side.
To prevent accidental erasure of a recorded
tape, use a screwdriver to remove one or
both of the cassette tape’s erase-protection
tabs. This prevents
RECORD from
engaging.
. . . .
If you later decide to record on a tape side
after you have removed the erase-protection
tab, place a piece of strong plastic tape over
that side’s erase-protection hole. Be sure
you cover only the hole originally covered by
the erase-protection tab.
52'%+(+%#6+105
Radio
Frequency ...................................................................................... AM: 520 – 1710 kHz (10 kHz per step)
......................................................................................................FM: 87.5 – 108.MHz (0.1 MHz per step)
Radio Channel Memory..................................................................................................... AM:10 channels
........................................................................................................................................... FM:10 channels
Cassette
Tape Speed .............................................................................................................. 1 7/8 ips (4.75cm/sec)
Recording System .......................................................................................................................... AC Bias
CD Player
Frequency Response ........................................................................................................ 100 – 20,000 Hz
Signal-to-Noise................................................................................................................ 60 dB (w/ BPF. A)
Sampling Frequency ..................................................................................................................... 44.1 kHz
Oversampling ................................................................................................................................. 8 Times
Harmonic Distortion....................................................................................................... (at 1 kHz) THD 1%
General
Power supply (Main unit)........................................................................................................... 120V 60Hz
(Remote control).................................................................................................. 2
×
1.5V (UM-3) batteries
Max output power (10% THD)................................................................................................................ 4W
Operation Temperature ............................................................................................. 32 –104° F, 1 – 40° C
Dimensions of Main Unit (HWD) .......................... 10 3 / 4
Ч 11 13 / 16
Ч 11 13 / 16 Inches (273 Ч 300 Ч 300 mm)
Dimensions of Each Speaker (HWD) ....................... 7 13 / 16
Ч
8 3 / 16
Ч
7 13 / 16 Inches (198
Ч
208
Ч
198 mm)
Weight (not including packing material) ................................................................................ 10 lb (4.53kg)
Specifications are typical. Individual units might vary. Specifications are subject to change and
improvement without notice.
.
"%#76+10"
.
Restoring Tape Tension and Sound
Quality
Be careful not to damage the cassette when
tapping it. Do not touch the exposed tape or
allow any sharp objects near the cassette.
Preventing Accidental Erasure
Removing the erase-protection tabs does not
prevent a bulk eraser from erasing a cassette
tape.
±
"016'"
±
"
If you use a metal or high-bias type tape, the
recorded sound might not be erased properly.