Roberts Radio 205 - Manual (Page 80)

79
Disabling alarms
1. To disable an alarm enter the alarm setup menu (see page 76) and rotate
the Tuning/Select control until the desired alarm is highlighted on the
display. Press the Tuning/Select control.
2. Rotate the Tuning/Select control until the 'Enable:' option is highlighted
on the display. Press the control.
3. Rotate the Tuning/Select control to highlight 'Off' and press the control.
4. Rotate the Tuning/Select control until the 'Save' option is highlighted on
the display then press the control to save the new setting. The chosen
alarm will now be disabled.
Controlling alarms in stand-by
When your radio is in stand-by the alarms can be controlled using the Alarm
button. This avoids the risk of disturbance to someone who is asleep.
1. To change the states of the alarms when in stand-by press the Alarm
button. The display will cycle through none, either and both alarms enabled.
2. To change the alarm settings while the radio is in stand-by, press and
hold the Alarm button. This will cause the Alarms menu to be displayed
(see page 76 step 3 onwards).
Snooze timer
1. The buzzer or radio alarm can be silenced for 5 minutes by pressing the
Tuning/Select/Snooze control. Should you wish for a longer snooze
duration this can be extended. Pressing the control again while the radio
is snoozed will set the available snooze time to 5, 10, 15 or 30 minutes.
2. While the snooze timer is active the remaining snooze time is shown next
to the flashing alarm icon on the clock display.
3. In order to cancel the Snooze timer while the alarm is suspended, press
the On/Off button. The display will briefly show an 'Alarm Off' message.
3
1-4
1
1,2