Radio Shack PRO-92 - Manual (Page 67)

67 Troubleshooting
RESETTING/INITIALIZING THE
SCANNER
If the scanner’s display locks up or does not work prop-
erly after you connect a power source, you might need to
reset or initialize it.
Important: If you have problems with the scanner, first
try to reset it to retain all memory. If that does not work,
you can initialize the scanner; however, initializing clears
all information stored in the scanner’s memory.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
Scanner is
totally inoper-
ative. No power. Check the batteries or
make sure the AC
adapter or DC adapter
is connected properly.
Recharge the recharge-
able batteries or replace
the non-rechargeable
batteries.
The AC adapter
or DC adapter is
not connected. Be sure the adapter’s
barrel plug is fully
plugged into the PWR
DC 9V jack.
The batteries
may be improp-
erly installed. Make sure the batteries
are properly installed
according to polarity
markings on the battery
holder.
Keypad does
not work. Keylock is turned
on. Turn off keylock.
Keys do not
work or dis-
play changes. Undetermined
error. Turn the scanner off
then on again, or reset
the scanner. See
“Resetting/Initializing
the Scanner.”
Problem Possible Cause Remedy
20-522b.fm Page 67 Thursday, September 7, 2000 9:41 AM