Hardware installation, Driver installation – Rosewill RC-400 User Manual
Page 3
Gigabit PCI Card RC400-LX User Manual
3
Hardware Installation
Follow the instruction given below to install the Gigabit Ethernet PCI
Card.
1.
Turn your computer off and remove the power plug from the plug
socket.
2.
Remove the cover from the computer case.
3.
Remove the metal cover plate on the rear of a free PCI slot.
4.
Insert the card into one free PCI slot and screw it firmly on the bracket
side.
5.
Place the cover back onto the computer.
6.
Insert the plug into plug socket.
Driver Installation
For Windows® 2000/XP/Server 2003
Once the Windows® 2000, XP and Server 2003 startup. Gigabit Ethernet
PCI Card will be detected by system. Following is the procedures for
installing Gigabit Ethernet PCI Card driver under Windows® XP Service
Pack 2 operating system.
1.
When Found New Hardware Wizard Window pop-up, please click
“Cancel” button to cancel the driver installation for the device at this
moment. The driver for this device will be installed in the next step.
2.
Please insert the CD driver bound with Gigabit Ethernet PCI Card into
your CD-ROM Drive.
3.
At the Windows desktop click Start, then Run.
4.
Type D:\ RC400-LX \Setup.exe, then click OK. (Change D: to match
your CD-ROM drive letter)
5.
Follow the on-screen instructions to complete the installation.
6.
Restart Windows to complete the installation.