Ryobi TS230 - Manual (Page 12)

Page 12
0
10
30
40 45
10
20
20
IN S
0
10
30
40 45
10
2 0
20
45
30
15
0
45
45
40
20
10
0
30
10 2 0 0
Fig. 7
Fig. 8
Fig. 9
ASSEMBLY
WARNING:
To prevent accidental starting that could cause possible
serious personal injury, assemble all parts to your saw
completely before connecting it to power supply. Saw
should never be connected to power supply when you are
assembling parts, making adjustments, installing or re-
moving blades, or when not in use.
As mentioned previously your saw has been factory as-
sembled and adjusted. The miter lock handle, work clamp,
dust guide, and blade are the only parts that have to be
installed.
MITER LOCK HANDLE
See Figure 7.
To install the miter lock handle, place the threaded stud on
the end of the miter lock handle into the threaded hole in
the miter table control arm. Turn clockwise to tighten.
WORK CLAMP
See Figure 8.
To install the work clamp, place the shaft of the clamp in
either hole in front of the miter table base. Thread the 8 mm
work clamp screw provided into the side of the base and
tighten it to secure the clamp in position. Rotate the knob
on the clamp to move the it in or out as needed.
WARNING:
When using the work clamp with the stop block, install the
clamp on the stop block side of the blade. This will
eliminate the possibility of the saw catching the loose end
and kicking up. Failure to heed this warning can result in
serious personal injury.
DUST GUIDE
See Figure 9.
To install the dust guide, place the end marked INSERT
over the exhaust port in the upper blade guard. Turn the
guide so that the open end is facing down.
WARNING:
A 10 in. (254 mm) blade is the maximum blade capacity
of your saw. Never use a blade that is too thick to allow
outer blade washer to engage with the flats on the spindle.
Larger blades will come in contact with the blade guards,
while thicker blades will prevent the blade screw from
securing the blade on the spindle. Either of these situa-
tions could result in a serious accident and can cause
serious personal injury.
TO INSTALL BLADE
See Figures 10, 11, and 12.
■ Unplug your saw.
TO
TIGHTEN
MITER
TABLE
CONTROL
ARM
TO
LOOSEN
MITER
LOCK HANDLE
MITER TABLE BASE 8 mm WORK
CLAMP SCREW
WORK CLAMP
DUST GUIDE UPPER
BLADE GUARD
EXHAUST
PORT