Ryobi TS230 - Manual (Page 15)

Page 15
30˚
40˚
45˚
10˚
20˚
30˚
40˚
45˚
0˚ 0˚
20˚
30˚
40˚
45
˚
10˚
20˚
30˚
40˚
45˚
0˚
20˚
30˚
40
˚
45 ˚
10˚
20˚
30˚
40˚
45
˚
0˚
Fig. 13
Fig. 14
Fig. 15
Fig. 16
ADJUSTMENTS
SQUARING THE MITER TABLE TO THE
FENCE
See Figures 13 - 16.
■ Push down on the saw arm and pull out the lock pin to
release the saw arm.
■ Raise saw arm to its full raised position.
■ Loosen the miter lock handle approximately one-half
turn.
■ Depress the miter lock plate and rotate the miter table
until the pointer on the control arm is positioned at 0
°
.
■ Release the miter lock plate and securely tighten the
miter lock handle.
■ Lay a framing square flat on the miter table. Place one
leg of the square against the fence. Place the other leg
of the square beside the zero clearance throat plate in
the miter table. The edge of the square and the zero
clearance throat plate in the miter table should be
parallel as shown in figure 13.
■ If the edge of the framing square and the zero clear-
ance throat plate in the miter table are not parallel as
shown in figures 14 and 15, adjustments are needed.
■ Using the 5 mm hex key (allen wrench) provided, loosen
the socket head screws located under the miter table.
See Figure 16. Adjust the miter table left or right until
the framing square and zero clearance throat plate are
parallel.
■ Retighten the screws securely and recheck the fence-
to-table alignment.
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
MITER TABLE
ZERO CLEARANCE
THROAT PLATE
FENCE
FRAMING
SQUARE
FENCE
MITER TABLE
ZERO CLEARANCE
THROAT PLATE
FRAMING
SQUARE
VIEW OF MITER TABLE NOT SQUARE WITH
FENCE, ADJUSTMENTS ARE REQUIRED
BOTTOM VIEW OF MITER TABLE
5 mm SOCKET
HEAD SCREW(S)
CORRECT VIEW OF MITER
TABLE SQUARE WITH FENCE
MITER
LOCK HANDLE
ZERO CLEARANCE
THROAT PLATE
MITER TABLE
MITER
LOCK PLATE
FRAMING
SQUARE
FENCE