Runco DTV-992 - Manual (Page 24)

6-2
Random Access Adjustment Mode
Selecting Setup Pattern
If an external source is connected to the projector, this menu will be displayed. Push
the control disc up or down to highlight the desired setup pattern and then press
ENTER.
Genlocked pattern : internally generated cross hatch pattern, locked on the external
source.
Internal # pattern : internally generated cross hatch pattern and locked on internal
generated sync signals. (no external source necessary)
If no external source is connected to the projector, the internal cross hatch pattern
menu will be displayed.
Note: The menus in the manual are created for an external source, connected to one
of the inputs, and the ‘Genlocked Pattern’ is selected.
Internal Cross Hatch Pattern
The internal # pattern menu will be displayed if the internal cross hatch pattern has
been selected or if no source is connected to the projector.
The table below lists the 8 fixed factory preset frequencies available. Another 8
blocks are custom programmable.
Push the control disc up or down to highlight the desired cross hatch frequency.
Push the control disc to the left or to the right to scroll to another page. Press
ENTER if the desired block is selected.
15.6/50 PAL/SECAM
15.7/60 NTSC
31.2/50 EDTV
31.5/60 IDTV
31.2/50 HDTVEUREKA
31.5/60 HDTV ATV
33.7/60 HDTV HIVISION
15.8/60 EGA 1
21.8/60 EGA 2
31.5/60 VGA 3
31.5/70 XGA 1,2
35.5/97 VGA 4
44.2/70 SUPER VGA 2
48.5/60 SUPER VGA 1
61.0/76 SUPER VGA 3
63.9/76 APOLLO
ENTER continues to Random Access Adjustment Mode or
Internal # Pattern Selection.
EXIT returns to Path Selection menu.
ADJUST returns to Operational mode.
ENTER continues to the Random Access Adjustment Mode.
EXIT returns to the Setup Pattern Selection menu.
Choose a setup pattern
from below :
SELECTED SOURCE
GENLOCKED PATTERN
INTERNAL # PATTERN
Source 01
Select with
then <ENTER>
<EXIT> to return or
INTERNAL # PATTERN
kHz / Hz
15.6/50
PAL/SECAM
15.7/60 NTSC
31.2/50 EDTV
31.5/60 IDTV
31.2/50 HDTV EUREKA
31.5/60 HDTV ATV
Select with
scroll with
<ENTER> to accept
<EXIT> to return or
or