Operation – Ryobi RY08510 User Manual
Page 13
13
n
Operate blower at the lowest possible throttle speed to
do the job.
n
Check your equipment before operation, especially the
muffler, air intakes, and air filters.
n
Use rakes and brooms to loosen debris before blowing.
n
In dusty conditions, slightly dampen surfaces when water
is available.
n
Conserve water by using power blowers instead of hoses
for many lawn and garden applications, including areas
such as gutters, screens, patios, grills, porches, and
gardens.
n
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
n
Use the full blower nozzle extension so the air stream can
work close to the ground.
n
After using blowers or other equipment, CLEAN UP!
Dispose of debris in trash receptacles.
n
Use the sweeper nozzle for the everyday blowing opera-
tion. This nozzle allows for more area to be covered during
the blowing operation.
n
The high velocity nozzle is specifically designed for wet
sticky leaves. It allows you to scrape wet leaves or debris
while operating the blower.
CRUISE CONTROL / THROTTLE LOCK
The Cruise Control (throttle lock) can be used to operate the
blower without holding the throttle trigger.
To engage the cruise control / throttle lock:
See Figure 12.
n
Pull cruise control lever back towards user, and stop at
the desired throttle setting.
n
To release the cruise control, push cruise control lever all
the way towards the front of unit.
Fig. 11
SWEEPER NOZZLE
HIGH VELOCITY
NOZZLE
Fig. 12
CRUISE CONTROL
(THROTTLE LOCK)
THROTTLE TRIGGER
OPERATION