Rhino Mounts NITRO FN20 - Manual (Page 142)

MAINTENANCE
FN20/FN14 NITRO 02/10 Maintenance Section 5-2
© 2010 Alamo Group Inc.
MAINTENANCE
Before operating your Rotary Cutter, make sure it is properly lubricated and thoroughly inspected. Only a
minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and
trouble free operation.
Always disengage the PTO before raising the Rotary Cutter for transporting or making
adjustments.
Lubrication
Do not let excess grease collect on or around parts, particularly when operating in sandy areas. The
illustrations below shows lubrication points. The chart gives the frequency of lubrication in hours, based on
normal operating conditions. Severe or unusual conditions may require more frequent lubrication (Figure Mnt-
R-0380).
Use Multi-Purpose Gear Oil P/N 00786250 when required in Gearbox. Use N.L.G.I #2 grease for all locations
designated with grease gun. Be sure to clean the fitting thoroughly before using grease gun. Failure to
maintain proper lubrication will result in damage to U-joints, gearbox, and/or driveshaft.