RCA RCA - Manual (Page 41)

39
Recording
Using Dual Remote with
AutoEdit
Use this VCR as the playback VCR and set it to respond to
VCR2 on the remote as described in Setting Up the VCR
section. Use your other compatible VCR as the recording
VCR, which should respond to VCR1.
1. Follow step 1–4 in the “Using Two VCRs for Copying
and Editing Tapes.”
2. Press VCR1 on remote to control recording VCR. Press
RECORD (REC), then PAUSE, to put recording VCR in
pause mode.
3. Press VCR2 on remote to control playback VCR.
4. Use FORWARD, REVERSE, and PLAY to locate the point
where you want to begin copying. Press PAUSE while
VCR is playing to put playback VCR in pause mode.
5. Press EDIT on remote to start the VCRs copying.
6. Press EDIT again when you want to pause copying.
7. Repeat step 4–6 as needed.
8. Press VCR1, STOP, then VCR2, STOP, when you are
finished.