Raritan Engineering toilet - Manual (Page 11)

WIRING
C. Mounting controls:
A. Push Button Switch: (see fig 11)
• Mount Push Button Switch in an accessible
location.
• Make certain wires can be routed to Push
Button Switch.
• Wire terminals must have clearance when
installed.
1. Drill 5/8" (16mm) hole.
2. Attach wires to Push Button Switch terminals (see
wiring section).
3. Install Push Button Switch through back of
mounting surface.
4. Install waterproof nut on Push Button Switch.
5. Secure in place with inner nut.
B. ME Toilet Control:
1. Cut out a hole per Fig. 12, mark
mounting holes using wall plate as guide.
2. Route wire to the toilet and control.
3. Secure control with gasket using two
screws.
C. Smart Flush Control:
1. Cut out a hole per Fig. 13, mark mounting
holes using wall plate as guide.
2. Route wire to the toilet and control.
3. Secure control using mounting
screws
Install the Warning Label (L322) where it can be
easily seen.
Mounting Remote Pump:
1. Locate remote pump between thru hull fitting and
toilet bowl.
2. Locate in an area away from berth to keep noise
level down.
3. Use Inline Strainer (optional) to avoid clogs.
4. Secure remote pump to the floor using four bolts
through the pump base.
11
Fig.11
1/4” min clearance from terminals
CUT OUT
Multifunctional Manual Switch
Fig. 12