Runco LIGHTSTYLE LS-7 - Manual (Page 29)

Installation
Runco LS-7 Installation/Operation Manual 13
PRE
L
IMINAR
Y
3.2
Quick Setup Table 3-1 gives a quick overview of the LS-7 installation process. The sections following
this one provide detailed instructions.
Installation should be performed by a qualified custom video
installation specialist.
Table 3-1. Installation Overview
Step Procedure
For Details, Refer
to page...
1 Choose a location for the projector 14
2 Mount the projector 19
3 Connect signal sources to the LS-7 21
4
Connect external controller to RS-232 port and/or IR repeater
system (optional) 25
5
Connect 12-volt trigger output to retractable screen or other,
+12V trigger-activated equipment (optional) 26
6 Apply power to the projector 27
7
Primary lens adjustments: projected image size (zoom), position
(shift) and focus 17, 27
8 Change the OSD Language (optional) 28
9
For rear-screen and/or ceiling-mount installations, select the
proper picture orientation 29
10
Projector calibration: adjust the following for each input; save
settings when finished:
Aspect ratio
Brightness
Contrast
Color level
Tint
Input position 35
Note