Roland SOLJET SC-500 - Manual (Page 66)

64
User's Reference
Making Corrections for Printing
When performing test printing for feed correction, load the material correctly (see "Setup for Printing -- Loading the
Material"). If the material is not loaded correctly, an accurate test pattern may not be output.
When you use the program to set a correction value for the amount of feed, the program’s setting takes priority. The
setting made with the control panel for the machine takes effect only in cases where the program does not perform
correction of the amount of feed.
This corrects for errors in the amount of feed of the grit rollers due the type of material.
Be sure to make this setting when you have replaced the material with a different type.
Correcting the amount of feed improves the dot-positioning accuracy in the feed direction, which can help enhance image quality.
Feed Correction
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
1 Press the [ ] key to make the following screen
appear on the display.
2
Press the [ ] key to make the
following screen appear on the display.
3
MENU
CALIBRATION CALIBRATION
PRINTING ADJ.
Check the test pattern and choose a
value with no displacement. 5
Press the [ ] key to make the following screen
appear on the display.
6
PRINTING ADJ.
ADJUST
Press the [ ] key to make the following screen
appear on the display.
7
ADJUST
-0.10% -0.10%
Use the [ ] and [ ] keys to set the value you
checked in step 4, then press the [ENTER] key.
8
ADJUST
-0.10% +0.20%
-2.0% to +2.0%
(In steps of 0.05%)
* Test printing prints the pattern in steps of 0.10%.
+0.30%
+0.25%
+0.20%
+0.15%
+0.10%
+0.05%
0.00%
-0.05%
-0.10%
-0.15%
Value with no
displacement
Current
setting
Test pattern
Press the [ENTER] key to start printing a test pattern. 4
* Printing a Pattern
in Steps of 0.10%
PRINTING ADJ.
TEST PRINT