Roland SOLJET SC-500 - Manual (Page 80)

78
Description of Keys
Default
value
Setting
range
Function Submenu
Top
menu
Key
— — — — This cuts off the material at the present location of the
blade tip. Press this to cut off the portion already printed
or cut from the roll.
You cannot sever a piece of material while printing or
cutting is in progress.
For more information, see "Remove the Material."
— — — — This enters the menu mode.
When a menu is displayed, the [ ] and [ ] keys
move to the next menu,
the [
] moves to a submenu, and the [ ] key
moves to the previous screen.
— — — — This is used to accept, execute, or save the item shown
on the display.
— — — — These move the material and the carriage.
When a menu is displayed, these move among the menu
items.
— — — — Holding down this key for 1 second or longer performs a
printing test in an area of approximately 108 mm x 18
mm (4.25 in. x 0.71 in.).
Before starting to print, you can carry out a test printing
to check the printing quality. For more information, see
"Setup for Printing -- Test Printing."
If there is a problem with the state of the heads, such as dot
drop-out, perform head cleaning.
— — — — Holding down this key for 1 second or longer performs
cleaning for the printing heads.
You can perform cleaning while in any state.
For more information, see "Maintenance -- Cleaning the
Printing Heads."
— — — — Holding down this key for 1 second or longer performs a
cutting test in an area of approximately 20 mm x 20 mm
(0.79 in. x 0.79 in.).
For more information, see "Setup for Cutting -- Test
Cutting"
If there are problems with the quality of cutting results
for the material, press the [CUT CONFIG] key and
adjust the cutting conditions.
MENU
LANGUAGE
— ENGLISH
JAPANESE
ENGLISH This sets the language for screen messages. You can
select either English or Japanese.
+
— — — — This forces the tool to move up or down.