Roland RK-300 - Manual (Page 191)

191
Settings
The point detected by the touch screen may drift as you use
the RK-300 for an extended time. If you notice such a drift,
you can correct it by calibrating the touch screen as follows.
1.
Access the main screen.
* If the main screen is not shown, press the [EXIT] button until
the main screen appears.
2.
Touch < Menu >.
The Menu screen appears.
fig.d-SetMenu3-3.eps
* There are three menu screens. Touch to switch
screens.
3.
Touch < Touch Screen >.
A screen like the following appears.
fig.d-TouchPanel.eps
* If you decide to cancel the touch panel position adjustment,
touch <Cancel>.
4.
Touch < Execute >.
5.
A point will be indicated. Touch this point.
fig.d-TouchPanelAdj.eps
• If you touch a point other than the indicated one, the drift
may become extremely severe. Be sure to touch the
correct point.
Calibrating the Touch Screen
(Touch Screen)
RK-300_e.book 191 ページ ２００８年９月１０日 水曜日 午後４時６分