Ricoh 450 - Manual (Page 140)

WHAT TO DO IF SOMETHING GOES WRONG
124
3
x CLEARING MISFEEDS
R CAUTION:
Important
❒ When clearing misfeeds, do not turn off the operation switch. If you do, your
copy settings are cleared.
❒ To prevent misfeeds, do not leave any torn scraps of paper within the ma-
chine.
❒ If paper misfeeds occur repeatedly, contact your service representative.
Note
❒ More than one misfed areas may be indicated. In this case, check every appli-
cable area. Refer to the following charts: A, B, C, D, E, R, P, U, Y, Z.
❒ You can find a sticker explaining how to remove misfed paper inside of the
front cover, upper side of the finisher.
❒ When the machine instructs you to reset originals, reset your originals to the
feeding position.
The display will indicate the number of originals you should return.
• When removing misfed paper, do not touch the fusing section be-
cause it could be very hot.
P
Y
R
D C
Z
A
B
E
U
ND4X0200
Chapter3 Page 124 Tuesday, May 19, 1998 1:59 PM