Radio Shack 22-1692 - Manual (Page 17)

17
Muting the Audio Alert
While the detector sounds a radar or safety alert signal,
you can press
MUTE to temporarily silence the detector.
When you press MUTE , the voice alert says, “mute on.”
The detector automatically resets the mute to off about
20 seconds after the radar or safety alert signal stops. Or,
you can simply press
MUTE again before it resets, and
the voice alert says, “mute off.”
Note: Laser alert signals are not affected by pressing
MUTE .
Selecting VG-2 Mode
VG-2 mode is pre-set to off. To turn on VG-2, hold down
MUTE until the voice alarm says, “VG-2 on.” To turn VG-2
off, hold down MUTE until the voice alarm says, “VG-2
off.”
22-1692.FM Page 17 Wednesday, September 11, 2002 8:35 AM