Radio Shack PGW170 - Manual (Page 3)

GUITAR AMPLIFIER
GUITAR
3 4
Push the battery cover in the front of the bodypack as per the
sketch map; install the provided 9 volt battery, taking care to fit it
with the correct polarity connected.
Switch on the bodypack transmitter. The red LED will come on for
one second and then go off. This indicates correct operation.
If the red LED stays ON or is dim, this indicates the battery is
low and should be changed. If the red LED does not come on at
all, it indicates the battery is dead, and you should change the
battery.
Adjust the volume control on bodypack until you get sufficient
sound from your speaker.
Refer to the installation diagram below.
Using the supplied audio cable, connect from the AF OUT jack socket to the
GUITAR INPUT socket on your guitar amplifier. Connect the mains power
adaptor from "DC 12V" jack to a suitable mains power socket.
6.35PLUG
WIRELESS TRANSMITTER
WIRELESS TRANSMITTER