Rosewill RC-303 - Manual (Page 2)

2-Serial/1-Parallel Port PCI Adapter RC303 User Manual
Overview
This PCI I/O card is a dual UART with 1284 printer interface port controller with PCI bus interface and
uses an all-in-one solution from NeMos Technology, which provides superior performance and
unmatched data transfer rates. The most advanced feature is it uses of a single interrupt, which is set
automatically by the host system and share among all on-board I/O ports and supports printer interface
as well as PS2, EPP & ECP modes.
Features
z Chipset: NetMos Nm9835
z OS power: Single 5V operation
z Bus: PCI 2.1s 32bit, 33MHz
z Data Transfer Rate: 1Mbytes/s (serial port)
z Data Transfer Rate: 1.5Mbytes/s (parallel port)
z Selectable receive trigger levels
z PCI compatible Dual UART
z Multi-mode compatible controller (SPP, PS2, EPP& ECP)
z Modem control signals
z On chip oscillator
z 16Byte transmit-receive FIFO (UART)
z Software programmable mode selects
z Programmable baud rate generator
z Support plug & play features and makes installation fast and easy.
z Supports Windows98, Windows95, Windows2000 & Windows NT 4.0.
Installing the PCI I/O controller card into your computer
Turn off your computer and all external devices connect it.
Remove the computer’s cover. Refer to your computer user’s manual for more details.
Find an available PCI slot and remove the metal bracket. Save the bracket screw for later use.
Align the PCI I/O controller horizontally with respect to the PCI slot and insert it into the slot firmly and
evenly. Take care not to force it into the slot. Once you have properly positioned the PCI I/O controller
card into the slot, fasten it to the computer case with the bracket screw you have saved.
Replace the computer’s cover.
Turn your computer on. You are now read to install the driver!
Driver Installation
Windows 95/98/2000
Once the PCI I/O card is installed and the computer is restarted, Windows will detect the board and
attempt to install driver for it.
1