RedMax US-1 EBZ5100Q - Manual (Page 15)

US-15
EBZ5100Q
U
S
9. Maintenance
■ IGNITION COIL AIR GAP
INSPECTION
• If the gap is out of standard or when
installing the coil or rotor, adjust the air
gap between the ignition coil and the
iron core of the rotor.
Air Gap:
0.40mm (0.35 ~ 0.45mm)
0.016" (0.014 ~ 0.017")
(1) Rotor
(2) Ignition coil
■ SHOULDER STRAP
• If the shoulder strap is damaged it may
break during use, thus causing the
product to fall and resulting in personal
injury. Follow the instructions below to
replace the shoulder strap with new
one.
• Pass the upper end of the strap
through the hanger, making the
FLAPPED SIDE OUTSIDE.
• Put the end of the strap through the
ring on the strap, and then push the
ring toward the hanger as close as
possible.
(1) Ring
The flap on the end of the strap works
as a stopper. Never install the strap
with the flapped side inside, or the unit
may fall from the operator, which could
result in injury to the operator and/or
damage to the unit.
Do not apply liquid type screw lock
glue on screws or bolts used to fix
plastics components. Adherence of
this type of glue may cause cracks on
plastics and end up with the breakage.
IMPORTANT
WARNING
F21
F22