Roland fm/am radio - Manual (Page 30)

30
MFX 08: REVERB MFX 09: LINE DRIVE
* This reproduces the distortion that occurs when an electrical cir-
cuit is slightly overloaded.
MFX 10: COMPRESSOR
Parameter Value Description
Type
ROOM1,
ROOM2,
STAGE1,
STAGE2,
HALL1,
HALL2
Type of reverb
ROOM1 : short reverb with high density
ROOM2 : short reverb with low density
STAGE1 : reverb with greater late rever-
beration
STAGE2 : reverb with strong early reflec-
tions
HALL1 : very clear-sounding reverb
HALL2 : rich reverb
Pre Delay 0.0–100 ms
Adjusts the delay time from the direct
sound until the reverb sound is heard.
Time 0–127 Time length of reverberation
HF Damp
200–
8000 Hz,
BYPASS
Adjusts the frequency above which the
high frequency content of the reverb
sound will be cut, or “damped.” If you do
not want to cut the high frequencies, set
this parameter to BYPASS.
Low Gain -15–+15dB Boost or cut in the low end
High Gain -15–+15dB Boost or cut in the high end
Balance
D100:0W–
D0:100W Volume balance between the direct sound
(D) and the reverb sound (W)
Level 0–127 Output Level
Parameter Value Description
Strength SOFT, HARD
HARD produces stronger distortion than
SOFT.
Type 1, 2 Varies the nuances of the distortion.
Drive 0–127
Degree of distortion
This also affects the volume.
Low Gain -15–+15dB Boost or cut in the low end
High Gain -15–+15dB Boost or cut in the high end
Level 0–127 Output Level
Parameter Value Description
Attack 0–127
This sets the time it takes until the level is
compressed after the input exceeds the
Threshold.
Threshold 0–127
Adjusts the volume at which compression
begins
Post Gain 0–+18dB Adjusts the output gain.
Low Gain -15–+15dB Boost or cut in the low end
High Gain -15–+15dB Boost or cut in the high end
Level 0–127 Output Level
ARX-02_e.book 30 ページ ２００８年３月７日 金曜日 午後７時２２分