Roland fm/am radio - Manual (Page 33)

33
NEW
This combines TINE EP (p. 22), reproducing a typical Electric Piano
sound of the late ‘70s through ‘80s.
DYNO
This amp type is a modification of OLD case or NEW case, and is
marked by a bright sound and distinctive distortion that occurs when
you play strongly. When used in conjunction with TINE EP (p. 22),
this will reproduce the Electric Piano sounds used in numerous
recordings of the early ‘80s.
Parameter Value Description
Tremolo Switch OFF, ON Turns the tremolo on/off.
Tremolo Sync OFF, ON
When this is set to “note,” the effect is
synchronized with the tempo
See “About Note” (p. 36).
Tremolo Rate
0.05–
10.00 Hz,
note
Frequency of the tremolo
Tremolo Depth 0–127 Depth of the effect
Tremolo Duty -10–+10
Specifies the duty cycle of the LFO
waveform used to apply tremolo.
Increasing this value will increase the
duty cycle of the LFO waveform for the
L-channel; the duty cycle for the R-chan-
nel will decrease.
Bass -50–+50
Amount of boost/cut for the low
frequency range
Treble -50–+50
Amount of boost/cut for the high
frequency range
Level 0–127 Output Level
Parameter Value Description
Tremolo Switch OFF, ON Turns the tremolo on/off.
Tremolo Sync OFF, ON
When this is set to ON, the effect is
synchronized with the tempo
See “About Note” (p. 36).
Tremolo Rate
0.05–
10.00 Hz,
note
Frequency of the tremolo
Tremolo Depth 0–127 Depth of the tremolo
Tremolo Shape 0–127
Adjusts the tremolo waveform
Values near 0 will approach a triangle
wave, and values near 127 will ap-
proach a pulse wave.
The effect will also change depending
on the Tremolo Depth setting.
Bass Boost 0–127
Amount of boost/cut for the low
frequency range
Filter Curve 0–127
Amount of boost/cut for the middle
frequency range
Over Tone 0–127
Amount of boost/cut for the high
frequency range
Limiter OFF, ON
Selects whether the limiter will be applied
(on) or not (off).
Level 0–127 Output Level
ARX-02_e.book 33 ページ ２００８年３月７日 金曜日 午後７時２２分