RIDGID BS14002 - Manual (Page 31)

31
SAW
HOUSING
Fig. 43
MAINTENANCE
LUBRICATION
All the bearings in this tool are lubricated with a sufficient
amount of high grade lubricant for the life of the unit under
normal operating conditions. Therefore no further lubrication
is required.
BRUSH
See Figure 43.
There is a brush located inside the saw housing, next to the
lower wheel. It helps protect the tire and wheel by brushing
off saw dust. As the brush becomes worn, it will need to be
adjusted or replaced.
n
Remove the screw then pull the brush off.
n Place the new brush in the groove.
n Retighten using the screw.
BRUSH
SCREW
LOWER
WHEEL