RIDGID TS3650 - Manual (Page 27)

27
Assembly Tips
1. The caster set consists of an upper
and lower assembly.
2. First put the upper and lower
assembly together following instruc-
tions below.
3. Loosely assemble all nut and screw
connections. After mounting the
assemblies on the table saw, adjust
frames on center, and then securely
tighten all fasteners.
4. When assembling the frames, Tube
Rear (27" long) and Tube Front
(13-7/8" long) must be assembled so
the large hole faces down towards the
floor. See the illustration before
assembling.
Upper Assembly
1. Locate the following hardware:
4 Hex Head Screw w/Washer,
1/4-20 x 1-1/2
2 Hex Nuts w/Serrated Flange 7/16
4 Lock Nuts 1/4-20
2. From the loose parts find the
following:
1 Plate Assembly
2 Tube Rear (27" Length)
1 Channel Rear
2 Casters
3. Assemble Tube Rear (27 inch length)
to each side of the Plate Assembly as
shown using four each 1/4-20 x 1-1/2
hex head screw and lock nut. Loosely
assemble at this time.
NOTE: The larger hole at the end of the
tube, opposite the plate assembly, must
face down.
4. Align rear channel with holes in the
rear tubes as shown. Assemble
caster through channel and tube as
shown. Fasten with 7/16 nut as
shown. Loosely assemble at this
time.
Assembling Herc-U-Lift™ Caster System
.SP6498 Belt Drive Saw 05/03 7/15/03 7:04 AM Page 27