Radio Shack TAD-759 - Manual (Page 9)

9
1. Set PULSE/TONE on the back of the
TAD to TONE .
2. Lift the handset and listen for a dial
tone.
3. Press any number except 0 .
Note: If your phone system requires
that you dial an access code (9, for
example) before you dial an outside
number, do not dial the access code
either.
If the dial tone stops, you have touch-
tone service. Leave
PULSE/TONE set to
TONE .
If the dial tone continues, you have
pulse service. Set
PULSE/TONE to
PULSE .
SETTING THE DAY AND
TIME
The TAD-759 records the day and time
each memo and message is recorded.
Follow these steps to set the day and
time.
Note: If you do not complete each step
within 8 seconds, the TAD sounds three
beeps and exits. Start again at Step 1.
1. Hold down SET until the TAD beeps.
The TAD announces, “Sunday,” and
01 appears on the display.
Note: If necessary, adjust VOLUME
on the right side of the TAD to the
desired listening level.
2. To change the day, repeatedly press
SKIP to move backward or REPEAT
to move forward until the TAD
announces the desired day.
3. Press STOP . The TAD shows the cur-
rently set hour and announces “AM”
or “PM.”
4. To change the hour, repeatedly
press SKIP or REPEAT .