Radio Shack PLD35MU User Manual
Page 7
1.6 Description of the Face of the Front Panel
1. POWER/MUTE BUTTON
2. ANG(i.e. TILT) BUTTON
3. RELEASE BUTTON
4. MODE BUTTON
5. AUX IN SOCKET
6. SEL BUTTON
AND VOL KNOB
7. SMALL MONITOR
8
. BAND BUTTON
10. UP and DN BUTTONS
11. EJECT BUTTON
12. 1/PLAY/PAUSE BUTTON
13. 2/INT BUTTON
14. 3/RPT BUTTON
15. 4/RDM BUTTON
16. 5/-10 BUTTON
17. 6/+10 BUTTON
18. USB SOCKET
19. RESET BUTTON
20. APS BUTTON
21. EQ BUTTON
22. CLK BUTTON
. IR REMOTE SENSOR
9
1.7 Description of the Unit Chassis Facet After removing the Front Panel
26 PIN FEMALE CONNECTOR
TAMPON-PICK
26 PIN FEMALE CO NNECTOR: when there is some dirt on the connec tor,
pleas e wipe it away from the c onnector.
1.8 Description of the Unit Chassis Facet After Sliding D own the Front Panel
LED indicators
* The L ED indicator s light all the time, they can help you operate during darkness.
1
2
3
4
5
6
10
7
9
8
11
12 13
14
15 16
17
18
19
20
21
22
MODE
CLK
4
RDM
6
+10
UP
DN
EQ
MU
DV D/VCD/CD /MP3/USB/MMC
REL
+
SEL
_
APS
BND
ANG
AUX
USB
5
-10
3.8 " TFT
1
INT
2
3
RPT
It is for adjusting the hue of the video output.
It is for adjusting the saturation of the video output.
It is for adjusting the sharpness of the video output.
5
It is for selecting your desired sound effect when there is not central speaker
and sub-woofer. There are 3 mode: LT/RT, STEREO, VSS.
LT/RT: When playing a disc with PRO LOGIC Dolby stereo effect, choose the
item, so it will output audio signal with vivid theatre effect.
STEREO: If you choose the item, when outputting audio signal with 5.1 channels,
it will output the left and right channels of signal ; when outputting audio signal
with 2 channels, it will output the common 2 channels of stereo signal.
VSS: If you choose the item, when playing a disc recorded with 5.1 channels,
the main channel speakers can output audio signal with VSS effect.
5
It is for selecting audio output mode
LINE OUT: It can linearly compress the audio signal. So the volume level is lower.
You should select the item at night.
RF REMOD: It can make the volume level higher. You should select it at daylight.
After selecting the compression mode of LINE OUT, set the item, so you can
adjust the linear compression ratio. If you set it to be FULL, the Peak-to-Peak
value of the audio signal is the minimum; if you set it to be OFF, the Peak-to-
Peak value is the maximum.
It is for selecting a desired audio output mode for the left and right ways of signal.
It is mainly for Karaoke of Ac3. There are 4 modes in all as follows:
STEREO, MONO L, MONO R, MIX MONO.
HUE
SATURATION
SHARPNESS
.19.5 SPEAKER SETUP
.l9.6 DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
SPEAKER SETUP
DOWNMIX
EXIT SETUP
DIGITAL SETUP
OP MODE
DYNAMIC RANGE
DUAL MONO
EXIT SETUP
DOWNMIX
PDF created with FinePrint pdfFactory trial version