RCA T13017WH - Manual (Page 6)

4
Setting Up the TV/VCR
Startup
AUTOMATIC CLOCK SET
What is your Time Zone?
1 Eastern
2 Central
3 Mountain
4 Pacific
5 Alaska
6 Hawaii
7 Don't know
AUTOMATIC CLOCK SET
Does your area observe
Daylight Savings Time
from April to October?
1 Yes, DST is observed
2 No
3 Don't know
AUTO CHANNEL SEARCH
Now scanning channel 1
AUTOMATIC CLOCK SET
The TV/VCR is now
setting the clock.
This may take
several minutes.
Press MENU to cancel
TV/VCR MAIN MENU
1 Programming
2 Picture Quality
3 Time
TIME
1 Set clock
SET CLOCK
Time --:-- --
(hour:minute)
Date --/--/--
SET CLOCK
Time 05:07 AM
Date 07/13/95 Thursday
Press CLEAR to correct
Press MENU to set
8. Set the clock and auto channel search automatically.
When the AUTOMATIC CLOCK SET screen appears, follow
these steps to automatically place channels in the TV/VCR’s
memory and set the clock using the Coordinated Universal Time
information transmitted by some broadcast stations.
A . Press a number (1-6) on the remote corresponding to the
time zone you live in. If you do not know your time zone,
press 7.
B . Press 1 if your area observes daylight savings time from
April to October, or press 2 if it does not. If you do not
know, press 3.
C . Press MENU on the remote if all antenna or cable connections
are completed. The AUTO CHANNEL SEARCH will be
performed, followed by automatic clock set.
If The Auto Clock Set was unsuccessful message appears,
then set the clock manually. The clock must be set before
you can use the timer recording or wake-up timer features.
If you change your cable or antenna signal, and need to
manually place channels in memory:
1 . Press MENU on the remote to display the TV/VCR MAIN
MENU .
2 . Press 5 to display the SETUP menu.
3 . Press 1 to Auto channel search.
Set the clock manually.
If the AUTOMATIC CLOCK SET was unsuccessful or you want
to manually set the clock:
A . Press MENU on the remote to display the TV/VCR MAIN
MENU .
B . Press 3 to display the TIME menu.
C . Press 1 to display the SET CLOCK screen.
D . Use the number buttons on the remote to enter the time
including AM or PM, month, day, and year. The day of the
week will automatically appear after you enter the year.
• Press 0 before single-digit numbers. Press 1 for AM or 2
for PM. Example: press 0, then 5, then 0, then 7, then 2
for a time of 5:07PM.
• Press CLEAR on the remote at any time to change
incorrect entries.
E . Press MENU on the remote to start the clock.
To display the time and date, press DISPLAY on the remote.