Runco CX-46HD - Manual (Page 33)

Installation
Runco CX-40HD/CX-46HD Owner’s Operating Manual 23
PRE
L
IMINAR
Y
RS-232 Controller
Connection Use a straight-through RS-232 cable with a 9-pin male connector to connect a PC or
home theater control/automation system (if present) to the RS-232 port on the Crystal
Series LCD; see Figure 3-11.
For more information about using this connection, refer to Serial Communications on
page 53.
Figure 3-11. RS-232 Control System Connection
Rear Panel
To PC or
Automation/
Control
System
DB-9
Male
Connector Pin Assignments:
2 Transmit Data
3 Receive Data
5 Ground
1, 4, 6, 7, 8, 9 Not Connected