RedMax EDG2300 - Manual (Page 13)

❲ 13 ❳
Maintenance
• Before cleaning, inspecting or repairing
your unit, make sure that engine has
stopped and is cool. Disconnect the
spark plug terminal to avoid accidental
engine starts.
■ Daily Inspection
• Remove grass or dust, from the entire
body.
• Check that all nuts and screws are
securely tightened, and no parts are
missing.
• Check for leakage of fuel.
■ Inspection every 25 hours
• Remove the air cleaner element from the
carburetor air intake cover and wash in
warm, soapy water. Dry completely before
installing.
WARNING
• Check and clean the spark plug. Adjust
the electrode gap to .024~.028in
(0.6~0.7mm) if necessary.
Replacement plug: CHAMPION RCJ-6Y
■ Inspection every 100 hours
• The muffler is equipped with a spark
arrester to prevent red hot carbon from
flying out of the exhaust outlet. In the
State of California it is required by law
(Section 4442 of the California Public
Resources Code) to equip a spark
arrester when a gas powered tool is used
in any forest covered, brush covered, or
grass covered unimproved land.
• Check and tighten each fastener.
• Dismount the engine and check the clutch
system to see if oil is observed between
the clutch lining and its drum. If any, wipe
it off with gasoline.
Cleaner element
Cleaner cover
Speak
Arrester
.024 ~ .028 in (0.6~0.7mm)