Ryobi RPW2500WB - Manual (Page 17)

17
OPERATION
 Push the nozzle into the quick-connect collar until it clicks
in place and is secured properly.
To disconnect a nozzle from the trigger handle once the
cleaning job is complete:

Turn off the pressure washer and shut off the water
supply. Point nozzle in a safe direction and pull trigger to
release water pressure.
 Engage the lock out on the trigger handle by pushing up
on the lock out until it clicks into the slot.
 Remove the nozzle by placing hand over nozzle then
pulling back the quick-connect collar. Place nozzle in the
nozzle holder for storage.
WASHING WITH DETERGENT
See Figures 22 - 23.
NOTE: When using detergent, the coiled high pressure
hose can be relocated to the hook-and-loop strap located
behind the handle bar instead of the strap located on the
carrying handle.
Use only detergents designed for pressure washers; house-
hold detergents, acids, alkalines, bleaches, solvents, flam-
mable material, or industrial grade solutions can damage
the pump. Many detergents may require mixing prior to use.
Prepare cleaning solution as instructed on the solution bottle.

Place the injection hose in the bottom of the detergent
bottle/container.
 Install the Soap Blaster™ nozzle on the spray wand.
 Spray the detergent on a dry surface using long, even,
overlapping strokes. To prevent streaking, do not allow
detergent to dry on the surface.
For long range detergent application:
With the Soap Blaster™ nozzle installed on the spray wand and
the engine shut off, pull nozzle up until it clicks into place.
For short range detergent application:
With the Soap Blaster™ nozzle installed on the spray wand
and the engine turned off, push the Soap Blaster™ nozzle
down as far as it will go.
DETERGENT
CONTAINER
INJECTION
HOSE
Fig. 22
Fig. 23
LONG
RANGE
SHORT
RANGE
SOAP BLASTER ™
NOZZLE