Roland CDX-1 - Manual (Page 91)

91
Arranging audio samples to create a song—Sequence
Arranging audio samples
to create a song
Recording while you listen to the playback of another
sequence track
You can select a sequence track for playback, and then perform realtime recording
while you listen to the playback of the selected sequence track.
1. As described in steps 1–3 of “Playing a sequence track” (p. 96), select the
sequence track that you wish to play.
2. Follow the procedure described of “Realtime recording,” above.
Recording will begin, and at the same time the sequence track you selected in step 1
will play back. Press pads to record them.
Recording while you listen to the playback of the audio tracks
When sequence is turned on ([SEQ PLAY] is turned on), all the lighting [STATUS] of
audio tracks will go dark (muted). At this time, you can select a audio track for
playback, and then perform realtime recording while you listen to the playback of
the selected audio track.
1. Follow steps 1–7 of “Realtime recording,” above.
2. For the audio track(s) that you wish to play, press [STATUS] to get it to light in
green.
* It is not possible for the sequence track selected as the recording destination to play simultaneously
with the corresponding audio track. And an audio track cannot be played back simultaneously with
the corresponding sequence track selected as the playing back destination. For details refer to
“Playing sequence tracks and audio tracks simultaneously” (p. 97).
3. Press [CREATE].
Recording will begin, and at the same time the audio track(s) you selected in step 2
will play. Press pads to record them.
4. When you are finished recording, press PAD SEQUENCING [CREATE].
[CREATE] goes out (extinguished), and the display returns to the Basic screen.
5. Return to the location where you begin recording, and press PLAY [ ] to play
back your performance and listen to the result.
After recording, you can press
[UNDO/REDO] (p. 138) to
return to the previous
conditions.
In step 4, if you press
STOP [ ], [CREATE] will
blink (recording-standby
mode). Then press [CREATE]
once again, recording will
begin.