Radio Shack 120-2130A - Manual (Page 13)

Note: If the stereo does not find a strong station when
seeking or scanning, the stereo searches the band
again and stops on weaker stations.
4. Adjust ON VOL, TONE, FADER and BAL as desired.
Note: To temporarily display the frequency of the current station, press
and release F/C. The display shows the frequency for 5 seconds, then
returns to the time display.
Memory Tuning
You can store up to six AM and 12 FM stations in memory. Each memory group
(AM1, FM1, and FM2) holds up to six stations.
You can let the stereo search for any six stations in a band and
automatically enter these into a memory group, or you can manually enter
stations into a memory group.
Automatically Storing Stations
Follow these steps to automatically enter stations into a memory group.
1. Repeatedly press AM/FM until the stereo displays the band and memory
group where you want to store a group of stations. For example, to
store the first group of stations into AM1, repeatedly press AM/FM
until AM1 appears.
2. Hold down AMS (automatic memory scan) for about 3 seconds. The stereo
automatically stores the first six strong stations on the selected
band.
After the stereo has stored all six stations into memory, it tunes to
the first stored station in the memory group and begins to play.
Note: You can store a station manually if the stereo does not
automatically store it due to a weak signal or interference. See
"Manually Storing Stations," below.
Manually Storing Stations
Follow these steps to manually enter stations into memory.
1. Repeatedly press AM/FM to select the desired band and memory group
(AM1, FM1 or FM2).