Radio Shack 120-2130A - Manual (Page 15)

press AMS. The radio begins scanning the stored stations - AM1 and AM2, or
FM1, FM2 and FM3.
Note: Do not hold down AMS. This causes the radio to automatically seek
and store six stations into the current memory group.
To stop the scanning when the stereo pauses at a station you want to
listen to, either press AMS or the station's memory location button.
Cassette Player Operation
Playing A Cassette
CAUTION: Avoid using C-120 cassette tapes. They are very thin and can
easily become tangled in the tape-handling parts.
Follow these steps to play a cassette tape.
1. Take up any slack by turning the cassette's hub with your finger or a
pencil. (Avoid touching the tape.)
2. Turn ON VOL clockwise until it clicks to turn on the radio.
3. Put the tape into the cassette compartment with its open edge to the
right and the side you want to hear facing up. The tape begins to play
and the direction indicator appears on the display.
4. Adjust ON VOL, TONE, FADER and BAL as desired.
5. Press IN /\ all the way to stop the tape and eject it.
CAUTION: We recommend you press /\ as soon as you finish playing a
tape or before you leave your vehicle, to release it from the
tape-handling parts. This reduces the possibility of a tape
being inadvertently tangled or damaged.
Notes: When the tape reaches either end while playing or fast-forwarding,
the cassette player automatically changes the tape's direction and
plays the other side of the tape. Play continues until you press /\
During play, you can switch to the other side of the cassette by
momentarily pressing << and >> at the same time until the direction
indicator on the display changes direction.
If you play a cassette tape several times, the tape can become
tight and cause distortion. To restore the correct tension, fast